Addonics Technologies UDFH7 User Manual

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)   

Phone: 408-453-6212 

Email: www.addonics.com/support/query/

Duplicator is USB 2.0 compliant. Works with USB 3.0 devices at 480Mb/s.

Works with the following devices:

- USB Flash media drive

- USB External hard disk

- Addonics Pocket Ultra DigiDrive (including PCMCIA storage devices or 

flash 

  storage with the Addonics adapters)

- Addonics Pocket eSATA/USB DigiDrive

- Addonics Pocket Micro SATA UDD

- Addonics Diamond or Ruby ExDrive, with or without Cipher feature, using 

  the Addonics USB 3.0 to eSATAp Adapter

- Any of the above USB storage devices used with the Addonics CipherUSB

NOTE: Using an external power supply with storage devices that support 

external power is strongly recommended.

Using the Duplicator with Adapters not supplied by Addonics is not 

supported or recommended.

Duplicating source media encrypted using the Addonics Cipher family of 

products can be done without using the Cipher hardware – which will result 

in encrypted duplicates. This requires the 

Setup option Copy Area to be set 

to “Whole Media.”

The Duplicator can copy media formatted as FAT16, FAT32, NTFS, ext2 or 

ext3 with the 

Setup option Copy Area set to “System and Files.” Copying 

NTFS media this way requires target media that is larger in capacity than the 

source.

1. Insert the source device into the source slot, and any target devices 

    desired.

2. Turn on the unit.

3. After a self-diagnostic, the unit will scan all ports and start on the Copy 

    function.

4. Press OK to begin.

5. The Duplicator can operate in Asynchronous mode if it is able to contain 

all of the source data in internal memory – about 200MB. Otherwise it will 

    operate in Direct mode.