Adams Infra-Red Heater User Manual

GAS BURNER

• Burner and controls CSA listed for United States and Canada
• Hot Surface ignition and electronic safety – No Pilot
• 60,000, 80,000, 100,000, 125,000, 150,000, 175,000,

200,000 Btu/hr input sizes (natural or propane gas)

• Combustion Air inlet collar
• Sight glass for monitoring burner operation
• Combustion air proving differential switch
• Electrical & gas controls separated from combustion 

air stream

• Burner Housing 18 GA. galvanized steel
• Electrical – 120 volt/60/1 ph
• CSA listed for Vented or Unvented applications
• (1) year limited warranty

TUBE SYSTEM

• Combustion chamber –10' x 4" OD, 16 gauge aluminized

steel with flared burner mounting flange

• Heat exchanger – as required, remaining system comes

in 10' or 5' 16 gauge aluminized steel

• Flared fitting pipe connector with draw bolts at each joint

for solid compression type fitting – no gaskets or draw bands

• 20' to 70' systems – Straight systems or optional “L” or “U”

shaped systems using 90 deg elbows. (see schedule for
tube lengths available) 

• 10 year limited warranty

REFLECTORS

• High polished parabolic reflectors standard 
• 8' or 4' lengths 
• Reflector shield and tube system supported by heavy gauge

wire hangers placed approx. 7' apart

FLARED PIPE FORMS

Male-Female Type Connection
Compression Fitting
No Clamps or Draw Bands

OPTIONAL FEATURES

• Outside combustion air inlet hood with flexible 4" diameter duct
• 90 deg elbows for “L” or “U” shaped configurations
• Diffuser “V” reflector for low mounting applications
• Vent cap adapter (4" dia steel to 4" dia class “B” vent pipe
• Line voltage thermostat
• 24 volt relay to convert line voltage thermostat to

24 volt thermostat

• Burner “ON” running light