Ackton P5000 User Manual

5

P5000 Series Owners Manual  12/16/04  5:16 PM  Page 5

surface

flush mount

mount

Begin by parking on a flat level surface, set brake and disconnect ground 

wire from battery. Measure the length of the bumper and mark the center 

point with a mark on masking tape. Divide the bumper as shown below. 

To protect the rear corner of the vehicle, mount sensors within 1' from 

the bumper ends.

NOTE:

The driver's side is considered the left side of the vehicle. 

The sensors are marked:

R=Right, CR=Center Right, CL=Center Left, L=Left 

Sensor installation will depend on the sensors supplied with the system 

either flush mount or surface mount. Locate your sensor type from the 

sensors below.

45-60cm

1/8

approx

approx

1/8

approx

2/8

approx

2/8

approx

2/8

flush mount with 

adjustable angle