Acclaim Lighting A5000 User Manual
21
MAINTENANCE
INSPECTION AND CLEANING
Perform the following inspection and cleaning procedures periodically as a preventive maintenance
measure to keep the Acclaim Camera System in optimal condition resulting in trouble-free operation
producing crisp, clear images.
measure to keep the Acclaim Camera System in optimal condition resulting in trouble-free operation
producing crisp, clear images.
Inspection - Routinely inspect each component of the Acclaim Camera System for possible
defects as follows:
defects as follows:
1. Camera Handpiece -
a. Check overall handpiece for chips, cracks or other irregularities.
b. Check the lens window for debris or spots.
c. Check the connector socket for damage.
b. Check the lens window for debris or spots.
c. Check the connector socket for damage.
2. Control Module -
a. Check for broken indicator lamp and switch.
b. Check all connector sockets for damage, loose or missing hardware.
b. Check all connector sockets for damage, loose or missing hardware.
3. Cables and Connectors -
a. Check cables for damaged or deteriorated insulation kinking or twisting.
b. Check connectors for loose, bent or missing pins.
c. Check that both quick-disconnect plug ends snap closed to snugly secure the Handpiece
b. Check connectors for loose, bent or missing pins.
c. Check that both quick-disconnect plug ends snap closed to snugly secure the Handpiece
Cable to the Camera Handpiece and Control Module connectors.
CAUTION:
TURN OFF POWER AND UNPLUG THE ACCLAIM CAMERA SYSTEM COMPONENTS
BEFORE PERFORMING CLEANING PROCEDURES.
BEFORE PERFORMING CLEANING PROCEDURES.
Cleaning - Clean each component of the Acclaim Camera System as necessary by performing the
following procedures.
following procedures.
1. Control Module - Use a non-corrosive surface disinfectant such as Birex® se.
2. Camera Handpiece - Following every patient use, the Camera Handpiece can be wiped
clean and disinfected with any non-corrosive surface disinfectant such as Birex® se.
3. Camera Window Lens - Remove debris or spots from lens window by cleaning with alcohol
and cotton swabs.
D
O NOT SPRAY CLEANING LIQUIDS OR DISINFECTANTS DIRECTLY
ON THE CAMERA HANDPIECE OR CONTROL MODULE
.
USE CARE
NOT TO ALLOW LIQUIDS TO RUN INTO INTERNAL CIRCUITRY
.
D
O NOT WIPE THE SURFACES USING BENZINE
,
THINNER
,
ETC
.
AS
THIS MAY DEGRADE THE FINISH
.
DO NOT ATTEMPT ANY INTERNAL SERVICE OF ACCLAIM CAMERA SYSTEM COMPONENTS
.
CONTACT YOUR LOCAL AUTHORIZED AIR TECHNIQUES DEALER FOR SERVICE
.
FAILURE TO
HEED THIS WARNING MAY RESULT IN EQUIPMENT DAMAGE AND VOIDING THE WARRANTY
.