Dynamic Distributors Switch Cubes User Manual
5
Installing the Display Module
The display module can be mounted either above or below the handlebar
by attaching the backing plate mounting tab to a handlebar clamp (not
included). The wires from the switch cubes will come out of the
handlebars, into the display housing, and plug into the appropriate
connector. The data wire from the front module is routed to the display
module and plugged into the appropriate connector. The data wire comes
with the end already crimped on, but it can be cut off and easily re-
crimped in the event you need to fish the wire through a small hole, or
shorten it (see crimping instructions). It is recommended that electrical
grease (not included) be used on the data cable and socket to help
prevent corrosion from moisture. Be sure to plug the cables into the
correct sockets as the unit can be damaged from improper installation.
They are labeled “L” & “R” (for Left & Right handlebar switches) and
“C” for Front Module.
by attaching the backing plate mounting tab to a handlebar clamp (not
included). The wires from the switch cubes will come out of the
handlebars, into the display housing, and plug into the appropriate
connector. The data wire from the front module is routed to the display
module and plugged into the appropriate connector. The data wire comes
with the end already crimped on, but it can be cut off and easily re-
crimped in the event you need to fish the wire through a small hole, or
shorten it (see crimping instructions). It is recommended that electrical
grease (not included) be used on the data cable and socket to help
prevent corrosion from moisture. Be sure to plug the cables into the
correct sockets as the unit can be damaged from improper installation.
They are labeled “L” & “R” (for Left & Right handlebar switches) and
“C” for Front Module.
I n s t a l l a t i o n