Delta Tau GEO BRICK LV User Manual
Geo Brick LV User Manual
Troubleshooting
255
Reloading PMAC firmware
The following steps ensure proper firmware reload/upgrade.
Step1: Power up the unit while holding the BOOT SW switch down.
Step2: Release the BOOT SW switch approximately 2-3 seconds after power-up.
Step3: Launch the Pewin32Pro2.
Step1: Power up the unit while holding the BOOT SW switch down.
Step2: Release the BOOT SW switch approximately 2-3 seconds after power-up.
Step3: Launch the Pewin32Pro2.
Run the PMAC Devices window under Setup > Force All Windows To Device Number.
Click Test for the corresponding communication method.
Click ok for message “The PMAC is in Boostrap Mode”
Click Test for the corresponding communication method.
Click ok for message “The PMAC is in Boostrap Mode”