Bosch SMS69L22GB Instruction Manual
en
9
As soon as the rinse-aid refill indicator P
is lit on the fascia, there is still a rinse-aid
reserve of 1 – 2 rinsing processes. Refill
with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l) only. If the water hardness is
over 21° dH, rinse aid must be used.
–
is lit on the fascia, there is still a rinse-aid
reserve of 1 – 2 rinsing processes. Refill
with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l) only. If the water hardness is
over 21° dH, rinse aid must be used.
–
Open the dispenser 1j by pressing
and lifting the plate on the cover.
and lifting the plate on the cover.
–
Carefully pour rinse aid up to the max.
mark in the filler opening.
mark in the filler opening.
–
Close cover until it clicks shut.
–
To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with a
cloth.
during the next rinse cycle, remove any
rinse aid which has run over with a
cloth.
Setting amount of rinse aid
The amount of rinse aid can be set from
§:‹‹ to §:‹‡. Please set rinse aid on
§:‹† to obtain very good drying results
(
(
§:‹† is already set in factory).
Change this setting, only if streaks (select
lower setting) or water stains (select higher
setting) are left on the utensils.
–
lower setting) or water stains (select higher
setting) are left on the utensils.
–
Open the door.
–
Switch on ON/OFF switch (.
–
Hold down programme button # and
press START button )" until
press START button )" until
•:‹.... is
indicated on the digital display.
–
Release both buttons.
The LED for button # flashes and the
digital display 8 displays the factory
setting
The LED for button # flashes and the
digital display 8 displays the factory
setting
•:‹….
–
Press programme button # until the
factory set value
factory set value
§:‹† is indicated on
the digital display 8.
To change the setting:
–
–
Press programme button 3.
Each time the button is pressed, the
set value increases by one level; when
the value of
Each time the button is pressed, the
set value increases by one level; when
the value of
§:‹‡ has been reached,
the display jumps back to
§:‹‹ (off).
–
Press START button )".
The set value is saved.
The set value is saved.
–
Close the door.
Switching off rinse aid refill
indicator
indicator
If the rinse-aid refill indicator P is
impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
–
impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
–
Proceed as described under “Setting
amount of rinse aid” and set the value
to
amount of rinse aid” and set the value
to
§:‹‹.
The rinse aid refill indicator P is now
switched off.
switched off.
Rinse aid %
PD[