Billion Electric Company 400G User Manual
Billion 400G Router
Chapter 4: Configuration
32
WPS
The WPS feature uses the Wi-Fi Alliance standard to allow easy set up of security-enabled Wi-Fi networks in the
home and small office environments. WPS supports two connection methods (via the routers Web GUI and through
the push button found on the rear panel) that will significantly reduce the number of steps required to set up the
network.
home and small office environments. WPS supports two connection methods (via the routers Web GUI and through
the push button found on the rear panel) that will significantly reduce the number of steps required to set up the
network.
Port Setting
This section allows you to configure the settings for the router’s Ethernet ports to solve some of the compatibility
problems that may be encountered while connecting to the Internet, as well allowing users to tweak the performance
of their network.
problems that may be encountered while connecting to the Internet, as well allowing users to tweak the performance
of their network.
Port # Connection Type: this is where you can customize the connection type of each of the routers
Ethernet ports. There are Six options to choose from: Auto, disable, 10M half-duplex, 10M full-duplex, 100M
half-duplex, 100M full-duplex and Disable. Sometimes, there are Ethernet compatibility problems with legacy
Ethernet devices, and you can configure a particular Ethernet port to one of the different types to solve
compatibility issues. The default is Auto, which users should keep unless there are specific problems with
computers not being able to access your LAN.
Ethernet ports. There are Six options to choose from: Auto, disable, 10M half-duplex, 10M full-duplex, 100M
half-duplex, 100M full-duplex and Disable. Sometimes, there are Ethernet compatibility problems with legacy
Ethernet devices, and you can configure a particular Ethernet port to one of the different types to solve
compatibility issues. The default is Auto, which users should keep unless there are specific problems with
computers not being able to access your LAN.
IPv4 TOS priority Control (Advanced users): TOS, Type of Services, is the 2
nd
octet of an IP packet. Bits 6-7 of
this octet are reserved and bit 0-5 are used to specify the priority of the packet.
This feature uses bits 0-5 to classify the packet’s priority. If the packet is high priority, it will flow first and will not be
constrained by the Rate Limit. Therefore, when this feature is enabled, the router’s Ethernet switch will check the
2
constrained by the Rate Limit. Therefore, when this feature is enabled, the router’s Ethernet switch will check the
2
nd
octet of each IP packet. If the value in the TOS field matches the checked values in the table (0 to 63), this
packet will be treated as high priority.