Bertazzoni 36 Drop-in Low Edge Cooktop 6-Burner Owner's Manual
5
Electrical connection
The connection of the hobs to mains is effected via the flex and the three pin plug located underneath the
hotplate. The appliance operate at a main voltage of 120V a.c., frequency 60Hz. Electric power absorption is
about 1W for 5 gas burner version or 2W for 6 gas burners version.
WARNING: Electrical Grounding Instructions: This appliance is equipped with a (three-prong)
grounding plug for your protection against shock hazard and should be plugged directly into a
properly grounded receptable. Do not cut or remove the grounding prong from this plug.
hotplate. The appliance operate at a main voltage of 120V a.c., frequency 60Hz. Electric power absorption is
about 1W for 5 gas burner version or 2W for 6 gas burners version.
WARNING: Electrical Grounding Instructions: This appliance is equipped with a (three-prong)
grounding plug for your protection against shock hazard and should be plugged directly into a
properly grounded receptable. Do not cut or remove the grounding prong from this plug.
Wiring diagrams
Wiring
diagram
description
For hotplate model A see Fig. 13.
1. Cable terminal
For hotplate model B see Fig. 14.
2. Ignition switch
3. Spark generator
4. Ignition spark
L. Black
N. White
T. Green (earth)
3. Spark generator
4. Ignition spark
L. Black
N. White
T. Green (earth)
Room ventilation – Location and venting.
ATTENTION: An exhaust fan may be used with the appliance; in each case it shall be installed in
conformity with the national standards in force.
ATTENTION: Exhaust hood operation may affect other vented appliances; in each case it shall be
installed in conformity with the national standards in force.
conformity with the national standards in force.
ATTENTION: Exhaust hood operation may affect other vented appliances; in each case it shall be
installed in conformity with the national standards in force.
Conversion to different types of gas
Before carrying out any maintenance work, disconnect the appliance from the gas and electric
supply. For Natural Gas fit regulator assembly described in Fig. 5. For LP Gas fit assembly described
in fig. 5.
- CHANGING THE NOZZLES FOR USE WITH OTHER TYPES OF GAS:
To change the nozzles of the burners use the following procedure:
Lift up the burners and unscrew the nozzles ( Fig. 8) using an adjustable spanner of 7 mm and change the
nozzles with those designed for the new gas supply according to the information given in TABLE A shown
below.
supply. For Natural Gas fit regulator assembly described in Fig. 5. For LP Gas fit assembly described
in fig. 5.
- CHANGING THE NOZZLES FOR USE WITH OTHER TYPES OF GAS:
To change the nozzles of the burners use the following procedure:
Lift up the burners and unscrew the nozzles ( Fig. 8) using an adjustable spanner of 7 mm and change the
nozzles with those designed for the new gas supply according to the information given in TABLE A shown
below.
TABLE A: Adapting to different types of gas
Drop-in cooktop with 5 workyop burners model B3H0..Q7X(2 or 5)D
Burner
Position Inj.
size
Gas
Pressure
Max Rate
Min Rate
By-pass size
1/100mm
Type
[i.w.c.]
[BTU/h]
[W]
[BTU/h]
[W]
[1/100mm]
Auxiliary
Front R
92
NG
4”
3750
1098
900
264
Regulated
56
LP(Propane)
11”
3750
1098
900
264
29
Semi-Rapid
Rear L
117
NG
4”
6000
1759
1500
439
Regulated
Rear
R
73
LP(Propane)
11”
6300
1845
1500
439
36
Rapid
Front L
155
NG
4”
10400
2046
2500
732
Regulated
98
LP(Propane)
11”
11400
3339
2500
732
47
Centre
Inner
80
NG
4”
900 264
Regulated
Dual
50
LP(Propane)
11”
NG 17000
4980
29
burner
Centre Outer
N°2 x 130
NG
4”
LP 18800
5507
Regulated
N°2 x 83
LP(Propane)
11”
65
Drop-in cooktop with 6 workyop burners model B3K0..U7X(2 or 5)D
Burner
Position Inj.
size
Gas
Pressure
Max Rate
Min Rate
By-pass size
1/100mm
Type
[i.w.c.]
[BTU/h]
[W]
[BTU/h]
[W]
[1/100mm]
Auxiliary
Front R
0,92
NG
4”
3750
1098
900
264
Regulated
0,56
LP(Propane)
11”
3750
1098
900
264
29
Semi-Rapid
Rear L & C
1,17
NG
4”
6000
1759
1500
429
Regulated
Front
C
0,73
LP(Propane)
11”
6300
1845
1500
439
36
Rapid
Front L
1,55
NG
4”
10400
2046
2500
732
Regulated
0,98
LP(Propane)
11”
11400
3339
2500
732
47
Centre
Inner
0,80
NG
4”
900 264
Regulated
Dual
0,50
LP(Propane)
11”
NG 17000
4980
29
burner
Centre Outer
N°2 x 1,30
NG
4”
LP 18800
5507
Regulated
N°2 x 0,83
LP(Propane)
11”
65