Behringer Mixer RX1202FX User Manual

EURORACK PRO RX1202FX User Manual

This illustration shows a typical arrangement for a live setup. Two vocal 

microphones and the line outputs of a guitar and a bass amplifier are connected 

to the mono channels of the RX1202FX. A keyboard and a drum computer are 

connected to the stereo channels. The power amplifier in your sound system is 

connected to the main outputs; equipment such as compressors, equalizers or 

crossovers are located between the mixer and the amp in the signal path. If you 

wish to make a  live recording, you can connect your recording equipment 

(in this case, a minidisk recorder) to the CD/TAPE outputs. A CD player that is 

playing during intermissions is connected via the CD/TAPE inputs. If you connect 

a recorder/player combo (e. g. a tape deck recorder), the CD/TAPE TO MIX switch 

should not be pressed during a recording because this way the signal intended 

for recording would be directly re-routed back to the mixing console, and then 

back to the recorder... this would cause a feedback loop as soon as you hit the 

record button. A loud, unpleasant, even painful sound would result.
Connect two monitor speakers over a power amplifier to the MON output 

which musicians can then use on stage. Determine the amount of the input 

signals (microphone, bass, keyboard, drum computer and guitar) in the mono 

and stereo channels that are to be sent to the MON output by using the MON 

controller of the corresponding channel.

AC POWER IN
The power supply is delivered through the power supply line to be found on 

the backside. The connection complies with the required security regulations.

You will need a large number of cables for different applications. 

The illustrations below show how the connectors should be wired. 

Be sure to use only high-grade cables.
Please use commercial RCA cables to connect the CD/tape inputs and outputs.
You can, of course, also connect unbalanced equipment to the balanced 

inputs/outputs. To do this, use either mono plugs or stereo plugs with the 

ring and sleeve bridged (pins 1 and 3 in the case of XLR connectors).

For unbalanced use, pin 1 and pin 3 have to be bridged

1 = ground/shield
2 = hot (+ve)
3 = cold (-ve)

1

2

3

1

2

3

Fig. 4.1: XLR connections

Fig. 4.2: 1/4" mono plug