Behringer U-Control UCA222 User Manual

U-CONTROL UCA222 User Manual

The most common application for the UCA222 is doing studio 

recording with a mixer. This will allow you to record several 

sources at once, listen to the playback, and record more tracks 

in sync with the original take(s).

•  Connect the mixer’s TAPE OUT to the INPUT RCA jacks on 

the UCA222. This will allow you to capture the overall mix.

•  Plug the USB cable into a free USB port on your computer. 

The POWER LED will light up.

•  Connect a pair of powered monitor speakers to the 

UCA222 OUTPUT RCA jacks. Depending on what type of 

inputs your speakers accept, you may need an adapter.

•  You may also monitor the input signal with a pair of 

headphones instead of or in addition to the monitor 

speakers. Turn the OFF/ON MONITOR switch to the ‘ON’ 

position. Plug a pair of headphones into the PHONES jack 

and adjust the volume with the adjacent control. This will 

be preferable if the mixer and computer are in the same 

room as the instruments being recorded.

•  Take some time to adjust each channel level and EQ to 

ensure a good balance between the instruments/sources. 

Once the mix has been recorded you will be unable to 

make adjustments to just one channel.

•  Set the recording program to record input from the UCA222.
•  Press record and let the music rip!

RCA Outputs

RCA Input

Computer             USB

B3031A

Active Monitor Speakers

XENYX 2222FX

HPM1000