Behringer Europower PMP960M Owner's Manual

EUROPOWER PMP1680S/PMP980S/PMP960M User Manual

3. Digital Effects Processor

24-BIT MULTI-EFFECTS PROCESSOR
This built-in effects module produces high-grade standard effects such as

reverb, chorus, flanger, delay and various combination effects. The integrated

effects module has the advantage of requiring no wiring. This way, the danger

of creating ground loops or uneven signal levels is eliminated at the outset,

completely simplifying the handling.
These effect presets are designed to be added to dry signals. If you move the

FX RET control, you mix the channel signal (dry) and the effect signal.

◊

Turn down the FX controls in those channel strips whose signals you
don’t wish to process.

4. Installation

4.1 Mains connection

Blown fuses must be replaced by fuses of the same type and rating.
The mains connection is made using the enclosed power cord and a standard IEC

receptacle. It meets all of the international safety certification requirements.

◊

Please make sure that all units have a proper ground connection.
For your own safety, never remove or disable the ground conductor
from the unit or of the AC power cord.

4.2 Audio connections

The inputs and outputs of the BEHRINGER EUROPOWER are unbalanced ¼" TS

connectors—except for the balanced mono line inputs. Of course, all inputs and

outputs work with both balanced and unbalanced connectors. The Tape Ins and

Outs are on stereo RCA connectors.

◊

Please ensure that only qualified personnel install and operate the
power mixer. During installation and operation, the user must have
sufficient electrical contact to earth. Electrostatic charges might affect
the operation of the unit.

Fig. 4.1: ¼" TS connector

strain relief clamp

sleeve

tip

sleeve

(ground/shield)

Unbalanced ¼" TS connector

tip

(signal)

Fig. 4.2: ¼" TRS connector

strain relief clamp
sleeve
ring
tip

sleeve

ground/shield

For connection of balanced and unbalanced plugs,

ring and sleeve have to be bridged at the stereo plug.

Balanced ¼" TRS connector

ring

cold (-ve)
tip

hot (+ve)

Fig. 4.3: XLR connectors

output

For unbalanced use, pin 1 and pin 3

have to be bridged

1 = ground/shield

2 = hot (+ve)

3 = cold (-ve)

input

Balanced use with XLR connectors

Fig. 4.4: ¼" TS connector for footswitch

strain relief clamp
sleeve

tip

sleeve

pole 1/ground

tip

pole 2

The footswitch connects both poles momentarily

¼" TS footswitch connector