LG D1453WF Owner's Manual

  Only use this feature when instructed to do so by the call centre.  

The transmission sounds similar to a fax machine, and so has no meaning except to the 

call centre.

  SMARTDIAGNOSIS™ can not be activated if the dishwasher does not power up.  

If this happens, then troubleshooting must be done without SMARTDIAGNOSIS™.

If you experience problems with your dishwasher, call the Customer information centre. 

Follow the call centre agent's instructions, and do the following steps when requested:

1.  Press the Power button to turn on the dishwasher. 

Do not press any other buttons.

2.   When instructed to do so by the call centre, place the 

mouthpiece of your phone very close to the Power button. 

(Max. 10mm)

3.   Press and hold the Delay Start button for three seconds, while 

holding the phone mouthpiece to the icon or Power button.

4.   Keep the phone in place until the tone transmission has finished.  

This takes about 17 seconds, and the display will count down the time.

• For best results, do not move the phone while the tones are being transmitted.

•  If the call centre agent is not able to get an accurate recording of the data, you may be 

asked to try again.

•  Pressing the Power button during the transmission will shut off the SMARTDIAGNOSIS™.

5.   Once the countdown is over and the tones have stopped, the machine will display END 

and turn off automatically after a few seconds. 

Resume your conversation with the call centre agent, who will then be able to assist you 

using the information transmitted for analysis at the call to Customer information centre.

SMARTDIAGNOSIS  function is available only for the products with a SMARTDIAGNOSIS  mark.

In case of a mobile phone with static option, the smart diagnosis function might not operate.