White Outdoor ZT-2150 User Manual

20

•

Remove the mower deck and the old mower deck 
drive belt from the mower deck.

•

Install and route the new belt according to the 
routing diagram. See Figure 26 or Figure 27.

•

Install the mower deck. Refer to Installing The 
Mower Deck.

•

Slide the mower deck under the Z-Series, making 
sure belt covers are removed.

•

From the rear, reach under the muffler cover and 
grasp the belt from the mower deck and bring it 
between the hydraulic units.

•

Bring the belt between the pulley and the clutch. Do 
not put the belt into the pulley grove yet.

•

From the front of the Z-Series, hold both front lift 
rods up and slide the mower deck forward until the 
lift rods go into the bracket.

•

Slide the mower deck backwards to insert the front 
lift rods into the brackets. See Figure 25.

•

Align the mower deck so the lift link aligns with the 
hanger bracket on the mower deck. See Figure 28.

•

Pull the support pin out and align with holes in 
hanger bracket and lift link.

•

Release the support pin so that it goes through both 
holes to secure deck. Repeat these steps for other 
side of the deck.

•

From the rear, attach the belt around the clutch 
pulley.

•

Engage tension bar by moving it into the bracket to 
maintain belt tension and replace belt covers.