Westinghouse WP2300 Owner's Manual

30 

1.  Remove the water inlet hose.

2.  Remove the cone-shaped water fi lter screen from 

the water inlet hose fi tting 

.

3.  Inspect the water fi lter screen for debris or damage.

4.  If the water fi lter screen is clogged or full of debris, 

clean it by fl ushing it with water on both sides. If it is 
damaged, replace it.

5.  Reinsert the water fi lter screen into the water inlet 

hose fi tting. The cone side has to face out.

1.  Remove the high-pressure hose.

2.  Inspect the O-rings on the hose fi ttings. Replace if 

cracked or split.

3.  Inspect the high-pressure hose for leaks or damage.

4.  Replace the high-pressure hose if it leaks or 

damage is present.

1. 

Inspect the O-ring on the wand where it connects to 
the spray gun. Replace if cracked or split.

2. 

Inspect the connection between the hose and the 
spray gun. Ensure that the hose is connected tightly 
to the fi tting on the spray gun.

3.  Release the blue trigger lock by slightly pushing the 

trigger forward.

4.  Test the trigger by pulling it backward. Make sure 

that the trigger returns to its original position when 
it is released.

1.  Remove the soap siphon hose (see Figure 37) from 

the soap container (if it is immersed).

2.  Inspect the soap siphon hose. Clean it if it is 

clogged.

3.  Inspect the soap siphon hose for leaks or damage. 

4.  Replace soap siphon hose if it is damaged.

1.  Shut off the pressure washer and turn off the water 

supply.

2.  Pull the trigger of the spray gun to release any 

remaining water pressure. 

3.  Remove the spray tip from the end of the nozzle 

extension 

.

4.  Remove any obstructions with a small paper clip or 

similar tool. 

5.  Flush the spray tip with clean water.