Westinghouse GEK1235W User Manual

23

INSTALLING

SAFETY WARNINGS ABOUT INSTALLATION

WARNING

•   The cooker MUST be installed and serviced by  

a qualified technician.

•   A Certificate of Compliance MUST be supplied  

to be kept by the customer.

•   The packing materials MUST be removed before  

you install the cooker.

•   You MUST follow the installation instructions in this booklet.

•   The surrounding kitchen cabinets MUST be able to 

withstand 85°C. Electrolux Products WILL NOT accept 

responsibility for damage caused by installation into 

kitchen cabinets which cannot withstand 85°C.

•   The vents, openings and air spaces MUST NOT  

be blocked.

•   You MUST NOT pull the cooker by the door handles  

or the splashback.

•  The cooker MUST be checked every five years.

Locating the cooker

Study the diagrams below to be sure of the dimensions 

required to locate the cooker safely.

TIPS & INFORMATION

Before you cook in your new oven it is important that  

the protective oils used in the manufacture of the product  

be removed.

•   Make sure that the room is well ventilated (to allow 

smoke to escape).

•  Run the grill on high for 30 minutes, without grill dish.

•  Then run the oven on 180°C for 2 hours. 

Wiring requirements

The cooker MUST be installed in compliance with

•  Wiring connections in AS/NZS 3000 Wiring Rules

•   Local regulations, municipal building codes and other 

statutory regulations

Data plate

•  

gives information about rating

•  is located on the inside panel  

of the grill door

Circuit diagram

•  is located on the back panel  

of the control panel

•   An all pole disconnect functional switch MUST be 

provided near the appliance in an accessible position  

(AS/NZS 3000 – Clause 4.7.1).

•   Wiring MUST be protected against mechanical failure 

(AS/NZS 3000 – Clause 3.9).

•   A means of disconnection with a contact separation  

of at least 3mm MUST be supplied in the fixed wiring.

WARNING

When connections are made to a multi-phase 240V supply, 

the bridge piece should be removed from between the 

active connections.

INSTALLING THE ELECTRIC COOKER

WMAN_540 Upright_Jun11.indd   23

28/06/11   12:07 PM