Weed Eater 186913 Owner's Manual

•      Raise hood.
•      Unsnap headlight wire connector.
•         Stand in front of tractor.  Grasp hood at sides, tilt toward 

engine and lift off of tractor.

•      To replace, reverse above procedure.

•      Raise hood.
•      Pull bulb holder out of the hole in the backside of the 

grill.

•      Replace bulb in holder and push bulb holder securely 

back into the hole in the backside of the grill.

•      Close hood.

Loose or damaged wiring may cause your tractor to run 
poorly, stop running, or prevent it from starting.
•     Check wiring.  See electrical wiring diagram in the 

Repair Parts section.

Replace with 20 amp automotive-type plug-in fuse.  The 
fuse holder is located behind the dash.

01536

The throttle control has been preset at the factory and 
ad just ment should not be necessary. Check adjustment 
as described below before loosening cable. If adjustment 
is necessary, see engine manual.

The car bu re tor has been preset at the factory and ad just ment 
should not be nec es sary. However, minor ad just ment may be 
required to com pen sate for differences in fuel, tem per a ture, 
altitude or load. If the carburetor does need adjustment, 
see engine manual.

•      Install new battery with terminals in same position as 

old battery.

•         First connect RED battery cable to positive (+) terminal 

with hex bolt and keps nut as shown. Tighten securely. 
Slide terminal cover over terminal.

•     Connect BLACK grounding cable to negative (-) ter-

 mi nal with remaining hex bolt and keps nut. Tighten 
se cure ly.