Room & Board Pisa Shelves Assembly Instruction
800.301.9720 | roomandboard.com
6/27/13
List of parts
1 – right leg
1 – left leg
1 – 6
1 – left leg
1 – 6
3
⁄
16
" shelf
1 – 7
9
⁄
16
" shelf
1 – 9
1
⁄
8
" shelf
1 – 10
5
⁄
8
" shelf
1 – 12
3
⁄
8
" shelf
1 – 14" shelf
Hardware
2 – L-brackets
8 – 1¼ wood screws
12 – bolts
8 – 1¼ wood screws
12 – bolts
Tools needed
Phillips screwdriver
drill with
drill with
7
⁄
64
" bit
pencil
Directions
1. Place right and left legs angle-side down on the floor with slots
facing in.
2. Insert the largest shelf into the bottom slot of the right leg. The
back of the shelf (indicated by a small drilled hole) must face the
floor. Insert bolt and tighten so that the shelf cannot fall out of
its slot but can still move freely within the slot.
floor. Insert bolt and tighten so that the shelf cannot fall out of
its slot but can still move freely within the slot.
3. Repeat step 2 for the remaining shelves from largest to smallest.
4. Attach the left leg to the left side of the shelves in the same
manner as the right leg.
5. Tighten all bolts. CAUTION: do not overtighten.
6. Position Pisa against the wall, and mark the wall at the top of
each leg immediately above each notch. Place the L-bracket
directly under the mark and screw into wall (see Figure 1).
Repeat with L-bracket for other leg.
directly under the mark and screw into wall (see Figure 1).
Repeat with L-bracket for other leg.
7. Drill holes into the top of each leg corresponding with holes in
the L-brackets. Insert screws through the L-brackets and into
the legs.
the legs.
MADE IN
North Dakota
MADE IN
North Dakota
Figure 1
ASSEMBLY INSTRUCTIONS: PISA