Kompernass KH 4300 User Manual
- 8 -
Thread tension selector 2 e
4. Pull the end of the thread about 10 cm (4”) out
from the looper eyelet.
5. Lift the sewing foot o and slide the thread under
it; then lower the sewing foot o back down. The
lever for lifting and lowering the sewing foot o
is located at the rear of the machine, above the
is located at the rear of the machine, above the
sewing lever rod system.
Position the lever to lift the sewing foot o
Thread routing behind the front flap 8
Thread routing on from the thread guide plate 8
Threading yarns into the needle
For simplification, the individual steps are numbered
on the illustrations (1
on the illustrations (1
q
, 2
w
, 3
e
, 4
r
, ...).
1. Turn the handwheel 6 to yourself until the needles
stand fully at the top.
2. Thread the left and right yarns as shown.
Thread tree 1 (on the left)
Thread guide r and thread guide plate t
(on the left)
(on the left)
IB_KH4300_33077_LB6.qxd 02.06.2009 13:40 Uhr Seite 8