High End Systems StudioPix Pixelation Luminaire User Manual

CHAPTER 2

Setup and Configuration

StudioPix™ Pixelation Luminaire User Manual 

9

If you are mounting the fixture(s) on a truss or another type of support, verify that the truss or 
support will handle the weight of all the devices you are mounting. 

High End Systems strongly recommends that you use a safety cable when mounting any fixture. 
You must supply your own safety cable and verify that the cable is capable of supporting the 
weight of the fixture. You can order galvanized safety cables from your High End Systems 
dealer/distributor (see Related Products and Accessories on page 3).

You must supply your own clamps and verify the clamp is capable of supporting the weight of 
the fixture. You can order deluxe C-clamps for a two-inch truss from your High End Systems 
dealer/distributor (see Related Products and Accessories on page 3).

To mount StudioPix fixtures on a truss:

1. Disconnect power to the fixture. If the fixture has been operating, allow the fixture to cool 

before handling.

2. Always stand on a firm, stable surface when mounting a fixture to its support. The fixture 

should be at a height where you can comfortably work on it, and should either be resting on 
a stable surface, or held securely. 

3. Attach suitable clamps through the center holes on the base of the fixture. Install two 

4. Tighten the clamps firmly to the fixture’s base and to the support.

5. Loop one or more suitable safety cables around the support, through the side holes in the 

fixture’s base, and around the fixture’s handles.

Holes for 
attaching 

clamps

Holes for 

securing 

safety cables

safety

cable

truss

clamp

locking

washers