Heartland Convection Oven 6210 User Manual

Burners A,B, E & F:
- Push the knobs in and turn in either direction to the setting desired.
- The higher number selected represents the higher temperature .
- At both the low (1) and high(7) settings, the control will "click" into position.
Control will also "click" and pop back up, in the off (0) position.
- Please be sure control knob is turned off (0) when your finished cooking.

Dual element has two cooking sizes available to select from in order to offer

the versatility to match the size of the heating element, to the size of the
cookware being used.

To use the 

inner surface heating element (5-6"):

- Push the knob in and turn counterclockwise to settings 1 through 3.
Control panel screening matches corresponding heating element selected.

To use the 

entire heating element (8-9"):

- Push the knob in and then to settings 1 through 5.

Control panel screening shows both inner and outer surface units heating

- The higher number selected represents higher temperature.

Bridge Burner operation - Burner D (48" models only):

Bridge Burner offers the versatility of using the rear element only or the rear

element and the bridge (Fig. A), the front element only (Fig. B) or all three

settings simultaneously, thanks to the two separate controls.

 To use the 

rear element only:

- Push the knob in and turn counterclockwise to settings 1 through 3.

 To use the 

rear and bridge sections:

- Push the knob in and turn to settings 1 through 5.

Control panel screening matches corresponding heating elements selected.

The higher number selected represent high temperature.

 To use

 front element in bridge burner:

- Push knob in and turn in either direction to the desired setting.

The higher number selected represents the higher temperature.
To use 

all three elements simultaneously:

- Operate both controls and turn to desired settings.

Indicator lights (all Burners):

A general burner indicator light will glow red when one or more radiant

heating elements are turned on, and will remain "on" until the last heating

element is turned off.
Each burner also has a dedicated light which will glow when the radiant ele-

ment is hot, and will remain "on", even after the control has been turned off,

until the surface is cooled to approximately 150 degrees Fahrenheit.

Fig. A

Fig. B