Graco 332234A - Hopper Kit for GH2570ES 5040ES 733ES 933 and 933ES Leaflet

1.

Set pump valve OFF. Turn engine OFF.

2.

Turn pressure to lowest setting. Trigger gun into pail to relieve pressure.

3.

Rotate handle counter-clockwise to open prime valve.

If you suspect that the spray tip or hose is completely clogged, or that pressure has not been fully relieved after following the 
steps above, VERY SLOWLY, loosen tip guard retaining nut or hose end coupling to relieve pressure gradually, then loosen 
completely. Then clean tip and hose.

GH733ES Bare

4000 psi (27.6 MPa, 276 bar)

GH5040ES Bare

5000 psi (34.5 MPa, 345 bar)

GH933ES Bare

7250 psi (50.0 MPa, 500 bar)

GH933 Bare

7250 psi (50.0 MPa, 500 bar)

IMPORTANT SAFETY INSTRUCTIONS
Read all warnings and instructions in 
sprayer manual. Save these instructions.

System pressure must be manually relieved to prevent it from starting or spraying accidentally. Fluid under high pressure can be 
injected into the skin and cause serious injury. To reduce risk of injury from injection, follow this procedure whenever you are instructed 
to relieve pressure, stop spraying, service equipment or install or clean spray tip. Read warnings, in operation manual.

332234A

Instructions

EN

ti20999a