Symbol MC70 User Manual
Using the MC70 2 - 23
Imager Scanning
1.
Ensure that a scan-enabled application is loaded on the EDA.
2.
Aim the scan window at the bar code.
Figure 2-18
Imager Scanning
3.
Press the scan button. The red laser aiming pattern turns on to assist in aiming. Ensure the bar code is
within the area formed by the brackets in the aiming pattern. The Scan/Decode LED lights red to indicate
that scanning is in process, then lights green and a beep sounds, by default, to indicate the bar code was
decoded successfully. Note that when the EDA is in Pick List Mode, the imager does not decode the bar
code until the crosshair touches the bar code.
within the area formed by the brackets in the aiming pattern. The Scan/Decode LED lights red to indicate
that scanning is in process, then lights green and a beep sounds, by default, to indicate the bar code was
decoded successfully. Note that when the EDA is in Pick List Mode, the imager does not decode the bar
code until the crosshair touches the bar code.
Figure 2-19
Imager Aiming Pattern: Bar Code Centered
Figure 2-20
Imager Aiming Pattern: Bar Code Not Centered
Linear bar code
PDF417 symbol
Symbol
View Finder
(Aiming Pattern)
Correct
Correct
Incorrect