Sierra Housewares S5010 User Manual
47
6
Maintenance
Troubleshooting Service Conditions
Your system notifies you if a keypad, sensor, or other system com-
ponent, needs service. When a service condition exists, the key-
pad beeps twice every 30 seconds for one minute. The display
shows the following message:
ponent, needs service. When a service condition exists, the key-
pad beeps twice every 30 seconds for one minute. The display
shows the following message:
PRESS Service
To get more information about the service message, press and
hold the
hold the
[service] key for two seconds. You then see one
of the messages listed in the table below. If there is more than
one message, you can view the next one by pressing
again. Follow the recommended course of action listed in the
table.
one message, you can view the next one by pressing
again. Follow the recommended course of action listed in the
table.
To stop the service message warning tone, enter your user code
between the two beeps.
between the two beeps.
When done, press
to exit.
What to do
Meaning
Message
AC POWER
LOSS
LOSS
BROWN OUT
PANEL LOW
BATT
BATT
GROUND
FAULT
FAULT
There is a power failure
in progress.
in progress.
A power loss, short of
total failure, has
occurred.
total failure, has
occurred.
The control panel's
battery is low.
battery is low.
Power from the system
has short-circuited to
the ground wire.
has short-circuited to
the ground wire.
Look for signs of power failure in other
building equipment; if not found, call for
service. Reset the clock and calendar,
once power is restored.
building equipment; if not found, call for
service. Reset the clock and calendar,
once power is restored.
When power returns to normal, your
system should revert to normal. If not,
call for service.
system should revert to normal. If not,
call for service.
Allow the battery to recharge overnight.
If the problem remains, call for service.
If the problem remains, call for service.
Call for service.