PVI Industries PV 9-A User Manual
PV 9 8/05 817-335-9531 ● 800-433-5654 ● FAX 800-880-2019 ● www.pvi.com
START-UP REPORT
OIL FIRED NON-CONDENSING WATER HEATERS
MAXIM
®
- TURBOPOWER
®
Warning: Startup must be performed by a qualified service installer, service agency or the gas supplier.
Model Number: Serial Number:
Job Name:
Address:
GENERAL INFORMATION
Restart?
Yes
No
Installation is:
New
Replacement/Renovation
Indoor
Outdoor
Primary operating voltage: VAC Voltage from neutral to earth ground:
(should be zero)
Lower Thermostat Setpoint:
°F Upper Thermostat Setpoint: °F Hi-Limit Setpoint °F
T & P Relief Valve(s) plumbed to a suitable drain?
Yes
No
WATER HEATER INSTALLATIONS
Type of piping connected to heater:
Copper
Brass
Galvanized
Is there a check valve in the supply water piping?
Yes
No
Is there a water softener on the cold water supply?
Yes
No Operational?
Yes
No
Is there a mixing valve on the hot water supply?
If yes; temperature setting: °F
No
Is there expansion relief in the cold water supply? If yes, what type:
tank
valve
No
Is there a recirculation loop?
Yes Circulating pump horsepower:
No
Is there a floor drain in the room?
Yes
No
VENTING and COMBUSTION AIR
Vent Material: Vent Type:
Through-the-roof
Through Sidewall
Vent Diameter:
inches; Vent Length: feet Does vent have elbows?
Yes; Qty
No
Does vent have condensate drain?
Yes
No
Does vent contain any of these devices?
Power Vent
Draft Inducer
Draft Regulator
Flue Damper
Combustion air louvers or openings?
Yes; Qty: Size:
No Interlocked?
Yes
No
Have direct-ducted combustion air?
Yes; duct diameter
inches, Duct length feet.
No
Duct Material: Does duct have elbows?
Yes; Qty
No
Page 1 of 2