Kamera Werk Dresden NOBLEX 135 User Manual

Page of 9
KAMERA WERK DRESDEN GmbH
Page 6 of 9
Rewinding the film
(1)  Press the rewind button (14) until it is engaged.
(2)  Lift out the crank on the rewind button  (9), turn  the crank in  the  direction  of the  arrow  to  rewind
the film.  Shortly  before  the  film  is  completely  rewound  resistance  on  the  rewind  knob  (9)  drops
considerably.
(3)  Pull up the rewind knob (9) as far as possible.
(4)  Open the camera back (25) and remove the film roll.
Short Time Exposures
(1)  Turn the camera on at the ON/OFF switch (10).
(2)  Switch the double exposure button (6) to single exposure (not to position »M«).
(3)  Rotate the speed range selector (7) counter clockwise.
(4)  Select your exposure time (1/30 -1/500) and set it on the shutter speed setting knob (2). The LED
indicator (3) should be green.
(5)  Set the aperture desired on the aperture selector wheel (1).
(6)  Turn the winding disk (5) in the direction of the arrow until it stops.
(7)  After carefully viewing your subject depress the shutter release button (4).
Please note
If the LED does not light,
1)  check your shutter speed selection and
2)  check the condition and/or insertion of batteries.
Pay  attention  to  the  proper  holding  of  the  camera.  Otherwise  your  hands  may  appear  in  the
photograph.
When  sighting  the  camera  horizontally  and
vertically  refer  to  the  circular  level  (12)
mirrored  in  the  finder.  Inclined  skylines  and
converging  vertical  lines  can  thus  be  reliably
avoided. The NOBLEX camera is a fixed-focus
camera.  A  distance  setting  is,  therefore,  not
necessary.  Please  refer  to  the  Technical
Features on page 9 or to the table on the back
of your camera (25a) for depth of field figures.
Mode  »A«  on  the  shutter  speed  setting  knob
(2)  can  only  be  used  together  with  a
PANOLUX  135  exposure  module.  Otherwise
inaccurate  exposures  may  occur.  It  is
advisable  to  switch  the  camera  off  (10)  when
not using the camera, to conserve battery life.
Long Time Exposures
(1)  Turn the camera on at the ON/OFF switch (10).
(2)  Switch the double exposure button (6) to single exposure (not to position »M«).
(3)  Rotate the speed range selector (7) clockwise.
(4)  Select your exposure time between 1/15 and 1 sec. and set it on the shutter speed setting knob
(2). The LED indicator (3) should be red.
(5)  Set the aperture desired on the aperture selector wheel (1).
(6)  Rotate the film advance knob (5) in the direction of the arrow until it stops.
(7)  After carefully viewing your subject. depress the shutter release button (4).
Please note
Refer to the hints at chapter »Short Time Exposures«. When taking  long time  exposures  it is  always
recommended to use a tripod.