TP-LINK TG-3269 Leaflet

FCC STATEMENT

The adapter has been tested and found to comply with the limits for

a class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

COPYRIGHT & TRADEMARKS

Specifications are subject to change without notice. is a

registered trademark of TP-LINK Technologies Co., Ltd. Other

brands and product names are trademarks or registered trademarks

of their respective holders.

No part of the specifications may be reproduced in any form or by

any means or used to make any derivative such as translation,

transformation, or adaptation without permission from TP-LINK

Consult the dealer or an experienced radio/TV technician for

help.

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including

interference that may cause undesired operation.

EC DECLARATION OF CONFORMITY (EUROPE)

In compliance with the EMC Directive 89/336/EEC, the adapter

meets the requirements of the following standards:

EN55022

EN55024

SAFETY NOTICES

Caution:

Do not use this product near water, for example, in a wet basement

or near a swimming pool.

Avoid using this product during an electrical storm. There may be a

remote risk of electric shock from lightning.

Thank you for purchasing TP-LINK TG-3269 10/100/1000M Gigabit

Ethernet Adapter. This document provides detailed guidelines to

install and use the adapter for network installers or users.

TG-3269 is a 32-bit PCI 10/100/1000Mbps NWay Gigabit LAN

adapter. TG-3269 provides extremely fast data transfer rates up to

2000Mbps at full duplex mode for high bandwidth usage in areas

such as network servers, workstations, Storage Area Networks

(SANs), Network Attach Storage (NAS) and high-speed video

streaming.

This manual is divided into two chapters and two appendices. The

following summarizes the contents of the chapters and appendices.

Chapter 1 Introduction

Hardware Overview

TG-3269 is a highly integrated and cost-effective single-chip Gigabit

Ethernet Adapter that provides 32-bit performance, PCI bus master

capability, and full compliance with IEEE 802.3 10Base-T,

IEEE802.3u 100Base-TX and IEEE 802.3ab 1000Base-T

specifications. It also supports ACPI, PCI power management for

modern operating systems that are capable of Operating System

Directed Power Management (OSPM) to achieve the most efficient

power management.

Through the aid of a VLAN membership, TG-3269 adheres to the

802.1Q for multiple VLAN support, and 802.1P for packet

prioritization. With 802.1Q support, server resources can be shared

with multiple VLANs when used in conjunction with any 802.1Q-

enabled Switch. With the 802.1p support, TG-3269 allows a range of

Ethernet packets to be prioritized from a critical to a non-critical

designation through a priority tag.

TG-3269 supports Full Duplex operations at 20/200/2000 Mbps data

speeds used in conjunction with 802.3x flow control support. With

802.3x flow control TG-3269 uses both asymmetric and symmetric

functions via the MAC control pause function. Any participating

802.3x flow control node can be controlled by initiating a pause

control to stop incoming network traffic, to further reduce network

congestion.

By default TG-3269 supports

me size. In

addition, TG-3269 can also be configured to use a maximum Jumbo

Frame size of

It includes an interface for a boot ROM and can be used in diskless

workstations, providing maximum network security and ease of

management.

Also, being PCI 2.2 compliant, TG-3269 works with 32-bit 33Mhz

PCI busses. This compatibility provides users with an easy migration

path to increase performance between servers and workstations for

large file transfer, video editing and server clustering for data

intensive applications.

Features & Advantages

Integrated Ethernet MAC, Physical chip and transceiver in one

chip

Complies with the IEEE802.1P, IEEE802.1Q, IEEE802.3

10Base-T, IEEE802.3u 100Base-TX and IEEE802.3ab

1000Base-T standard

Compliant to PCI Revision 2.1/2.2

the standard 1518 Byte fra

up to 7680Bytes.