Citrix Systems Network Router NETSCALER 9.3 User Manual

install option. You can also start NSWL
client from Start > Control Panel >
Services.

nswl -stopservice (Windows only)

Stops the NSWL client.

nswl -remove

Remove the NSWL client service from
the registry.

Run the following commands from the directory in which the NSWL executable is located:

w

Windows: \ns\bin

w

Solaris and Linux: \usr\local\netscaler\bin

The Web server logging configuration files are located in the following directory path:

w

Windows: \ns\etc

w

Solaris and Linux: \usr\local\netscaler\etc

The NSWL executable is started as .\nswl in Linux and Solaris.

In the NSWL client configuration file (log.conf), add the NetScaler IP address (NSIP)
from which the NSWL client will start collecting logs.

1. At the client system command prompt, type:

nswl -addns -f < directorypath > \log.conf

< directorypath >: Specifies the path to the configuration file (log.conf).

2. At the next prompt, enter the following information:

• NSIP: Specify the IP address of the NetScaler appliance.

• User name: Specify the user name of the NetScaler appliance.

• Password: Specify the password.

Note:  If you add multiple NetScaler IP addresses (NSIP), and later you do not want to
log all of NetScaler system log details, you can delete the NSIPs manually by
removing the NSIP statement at the end of the log.conf file. During a failover setup,
you must add both primary and secondary NetScaler IP addresses to the log.conf by
using the command. Before adding the IP address, make sure the user name and
password exist on the NetScaler appliances.

Chapter 4

Web Server Logging

104