Antari Lighting and Effects DNG-100 User Manual

 

3

items are included with your model.  If any equipment is missing contact your 
ANTARI dealer immediately. 
 
Before beginning initial setup of your ANTARI Fog Cooler, make sure that there is no 
evident damage caused by transportation.  In the event that the unit’s housing or 
cable is damaged, do not plug it in and do not attempt to use it until after contacting 
your ANTARI dealer for assistance. 
 
Setup 
♦  Remove all packing materials from shipping box.  Check that all foam and plastic 

padding is removed, especially in the nozzle area. 

♦  Attach power cord to rear of fog cooler. 
♦  Place the fog cooler’s intake within six inches (15 cm) of a fog machine’s output. 
♦  Plug power cord into a grounded electrical outlet.  Turn power switch on rear of 

unit to ”ON” position.   

♦  Waiting time for cooling is approximately two minutes. 
 
Operation 
♦  ANTARI Fog Cooler’s output volume is determined by the output volume of the 

fog machine to which it is attached. 

♦  Your ANTARI dealer has the hoses and adapters required for an optimal  

installation of the fog cooler.  See the two illustrations below: 

 
In the first example, a fog conducting hose (FT-10) is attached to a fog machine’s 
output nozzle via an adapter (FTA-1 or FTA-2) and then connected to an adapter 
(FTA-10) attached to the fog cooler’s intake. 
 

 

 
In the second example, substitute the guide plate (FTA-12) with a fog conducting 
hose (FT-10) that attaches to the front of the fog cooler via an adapter (FTA-11).  
This configuration allows the fog cooler’s output to be guided to a desired area 
without being affected by air currents generated by movement, wind, fans or air 
conditioners.