Mobility Electronics PS6U1UHE User Manual
InVision USB-Host to Ethernet Adapter User Guide
After the CAB file installation completes, you will need to warm boot the MC1000
by pressing and holding the red ON/OFF button until the device resets. This
process will add eConnect to your Applications Folder. Consult your MC1000
process will add eConnect to your Applications Folder. Consult your MC1000
documentation if you need help with performing a warm boot.
Be careful when performing a “warm boot” on the MC1000. The same activity
relax
that initiates a “warm boot” will also initiate a “cold boot.” They are only a
matter of seconds apart between a “warm” or “cold” boot. The results,
however, can be significant. A “cold boot” will remove all data and
applications and return the MC1000 to a default factory status. You can
however, can be significant. A “cold boot” will remove all data and
applications and return the MC1000 to a default factory status. You can
a little, however, because eConnect will automatically reinstall itself for you.
Step 5 – Co figuring eConnect™
nd highlight the
ay
opens, you can
Events
ically
adle
ctiveSync – If checked, the
e
n
Open the Applications folder, a
eConnect icon. Press the ENTER button to displ
eConnect icon. Press the ENTER button to displ
the eConnect Properties dialog.
When eConnect Propertied dialog
When eConnect Propertied dialog
configure eConnect as follows:
Use eConnect for Docking
When checked, eConnect will automat
sense when the terminal is inserted into a cr
sense when the terminal is inserted into a cr
and will carry out the options you have selected
in the When Docked area.
When Docked
in the When Docked area.
When Docked
o
Launch A
terminal will attempt synchronization
terminal will attempt synchronization
when a connection is detected. This can
happen only if the terminal and a PC hav
happen only if the terminal and a PC hav
partnership. ActiveSync is launched with the system settings
established by the user.
established by the user.
a previously established
C
two options, if either of them was checked.
two options, if either of them was checked.
hecking this option automatically un-checks the next
o
Establish TCP/IP Connection – Establishes a TCP/IP connection
with the cradle, allowing applications to bypass ActiveSync and
with the cradle, allowing applications to bypass ActiveSync and
communicate directly with nodes on a network via TCP/IP.
C
“Launch ActiveSync” option, if it was checked.
hecking this option automatically un-checks the
o
Launch Application – Specifies that eConnect should automatically
launch an application when you cradle the terminal. Any file that has
an association with a registered program will run. You may also elect
an association with a registered program will run. You may also elect
to launch a shortcut if the session needs special settings or command
line parameters.
line parameters.
4
Mobility Electronics, Inc