LG MODEL STRIKER S160 User Manual

USA - The floor in front and under the heater must be protected

with a minimum of 3/8” (10 mm) thick noncombustible material.

The  covering  must  extend  16”  (406  mm)  in  front  of  the  door

opening of the heater and 8” (203 mm) to either side of the door

opening and 5-1/2” (140 mm) to the rear or to the wall, whichever

is smaller. In all installations a 16” (406 mm) minimum hearth

extension (in front of the stove) is required as measured from the

door opening of the unit.

Canada - The floor in front and under the heater must be protected

with a minimum of 3/8” (10 mm) thick noncombustible material.

The covering must extend 457 mm in front of the door opening of

the heater and 200 mm to either side of the stove body and 200

mm to the rear or to the wall, whichever is smaller. In all installa-

tions a 457 mm minimum hearth extension (in front of the stove)

is required as measured from the door opening of the unit.

Clearances to combustible surfaces can be reduced with the use of

listed double wall connector pipe. See the clearances with double

wall pipe on the following page.

Single Wall Pipe - Minimum 48" (1219 mm) width, maximum 48"

(1219 mm) depth. Minimum ceiling height is 84” (2134 m).

Double Wall Pipe - Minimum 44" (1117 mm) width, maximum 48"

(1219 mm) depth. Minimum ceiling height is 72” (1829 mm).

All mobile home installations require an outside air kit (cat. no.

71111 or 71112). The stove must be bolted to the floor and

grounded to the chassis of the mobile home.

Approved Chimney* - Your stove is approved for use with Class

A, UL 103 HT (U.S.) / ULC-S629 (Canada) Listed Residential Type

and Building Heating Appliance Chimney (HT chimney - 2100°

Fahrenheit)  and  double  wall  connector  pipe  from  Security™ 

Clearances to connector shall be measured from 6" flue collar.

Restrictions apply! Read instructions before installing.

Minimum 6" diameter, minimum 24 MSG black steel connector

pipe with listed factory-built chimney suitable for use with solid

fuels or masonry chimney. Horizontal connection not tested, refer

to local building codes for installation. Restrictions apply! Read

instructions before installing.

Clearance dimensions are to 6” (152 mm) flue collar. If a single

wall  connector  pipe  with  shield  is  used,  a  1  inch  air  space  is

needed between pipe and shield. Shield attaches to rear of stove

pipe and must run from stove top to ceiling. Pipe shield shall be

UL listed.

Residential chimney systems must be from the same brands as

listed for mobile homes but connector pipe may be double wall,

single wall or single wall with shield as listed above.

Connector pipe and chimney must be of the same brand.

The chimney connector shall not pass through an attic or roof space,

closet or similar concealed space, or a floor, or ceiling. Where

passage through a wall, or partition of combustible construction

is desired, the installation shall conform to CAN/CSA-B365.

There must be an effective vapor barrier at the location where

the chimney or other component penetrates to the exterior of the

structure. Follow the vent manufacturer's detailed instructions.

IMPORTANT  NOTE:    See  Draft  Requirements  and  Selecting  a 

Proper Venting System on Page 4 to assist you in choosing the

proper venting system for your installation.

Legs AND Bottom Heat Shield or Pedestal Base.

* Other approved chimney brands are Projet, Jakes Evans/GSW,

Dura-vent, Metal Fab, Ameri-Tec, Metalbestos and Industrial

Chimney (ICC).