Infinity Softworks Prelude User Manual

PRELUDE MTS-STAND

Installing the Tower onto the Floor Stand

– When using the tower as a surround speaker,

set Toggle Switch in tower cup to “Full Range.”When using as

a front channel,set Toggle Switch in tower cup in bottom to

the “Full Range”position.Please consult the Prelude MTS

Subwoofer manual for exceptions to this setting.

TEP

– Insert double-ended Audio Banana Plug into tower

as shown.

TEP

– Screw alignment pins into cup in bottom of tower.

Use two per tower. Screw threaded ends into holes and tighten

until snug.DO NOT overtighten.

– To add greater stability to the tower stand,add

sand (not included) in the plastic bag provided in the tower base.

Turn the base upside-down and remove the (3) 1/4-20 Phillips

screws holding the foot onto the base.

TEP

– Remove one foam pad,pull out the plastic bag and open

it.Place it back into the opening of the base, taking care to fold it ove r

the sides so as to keep sand from falling into the base. Fill the plastic

b ag with sand.

TEP

– Seal the plastic bag,making sure to tuck it back

inside the base and place the previously removed foam pad on

top of the sealed bag.Replace the foot with the same 1/4-20

Phillips screws.

TEP

– Turn stand over and slowly lower the tower

assembly onto the stand,being careful to insert the alignment

pins into their receptacle guide holes.

TEP

– Fasten the four

10-32 Socket Head Screws

through the tower base as

shown;two through the front

baffle and two in the rear slot.

Press flush into place two

screw caps to hide holes in

front-baffle base. Make sure

that the alignment slots point

toward the center to ensure that

the surface curve matches that

of the baffle.

TEP