Amana AGK01 Installation Instruction

9

230/208 Volt Units

265 Volt Units

Heater Size

(kW)

Power Cord

Rating (amp)

Power Cord

Rating (amp)

1.5

15

20

2.5

15

20

3.5

20

Not Applicable

3.7

Not Applicable

20

5.0

30

30

NOTE: Heaterless units are shipped with an auxiliary data label

on the front side of the mid-partition panel.  If an electric heater

kit is field installed, the installer must mark the appropriate box on

the label to indicate the electric heater capacity. If no heater is

installed, the box labeled “None” must be marked. Refer to the

unit nameplate for over current protection data.

Once the unit is properly wired, measure the unit supply voltage.

Voltage must fall within the voltage utilization range given in

Table 2.

Unit Voltage

Rating

Minimum

Maximum

230/208

197

253

265

238

292

115

103.5

126.5

Voltage Utilization Range

A six button touch key pad located behind the control door

controls both temperature and operation mode. The key pads can

be used alone or in combination.

Pressing the COOL thermostat control and the up or down arrows

will provide a cooler  room temperature, respectively.  Pressing

the HEAT thermostat control and the up or down arrow keys will

provide a warmer room temperature.

230/208V and 115V units are equipped with LCDI or AFCI power

cords and can open the electrical circuit to the unit.  In the event

the unit does not operate, check the reset button located on or

near the head of the power cord as part of the normal trouble-

shooting procedure.

The fan speed touch key will deliver high, low or auto fan speed

to circulate room air.  NOTE: The AUTO selection will not be

available if a fan speed is selected without COOL or Heat

selection.

Fan Operation HIGH or LOW with HEAT or COOL mode selected

- The selected fan speed shall run in the selected speed.

Fan Operation AUTO with HEAT or COOL mode selected - The

fan will run in low and high speed. The changes in fan speed are

automatic.

The green diagnostic light located in the lower left hand corner of

the touchpad and indicates operation warnings.  This light usually

indicates that either the filter or coils need cleaning.  Please refer

to the Maintenance and Cleaning section for the proper cleaning

procedure.  If this light is still on after cleaning, please refer to the

Diagnostic & Status Report section for assistance.

Status LED