Dacor DCT365BLPH Installation Instruction

Installation Instructions

SimmerSear™ Burner Assembly

Igniter 

Burner cap 

(bottom shown)

Inner burner cap 

(bottom shown)

Outer burner cap

Burner ring

Burner ring

Burner base

Burner base

Line up 

indentations on

bottom of burner 

ring with pins on

top of base.

Installing the Burner Components

•  Never attempt to operate the cooktop with any of the 

burner parts removed.

•  Do not attempt to adjust the burner air mixture set-

tings. All adjustments are preset at the factory.

1.  Remove the burner rings, burner caps and grates from 

their shipping packages.

2.  Assemble the burners as shown. Match the burner 

parts to the correct size and type of burner. When 

installing the burner components, make sure they are 

centered. Twist each piece back and forth slightly until 

it drops completely into place. The burners will not 

operate properly unless all of the burner pieces are 

properly seated.

3.  Gently set the grates on top of the spill tray. Make sure 

that the rubber feet are positioned in the dimples.   

Each grate is different. Orient them as shown. Each grate 

has a slot on the bottom that matches up with a notch on 

the spill try. The slots on the grates all go toward the back 

of the cooktop.

Fit hole in burner 

ring over igniter

CAUTION: Top of 

igniter is sharp

SimmerSear™ 

burner

Standard 

burner

Slot on 

bottom

Slot on 

bottom

Slot on 

bottom

Left grate, 

curved fingers 

on left

Center grate

Right grate, 

curved fingers 

on right

Notch