Houzer 33228BS41 Installation Instruction
Insert clips into the channel, placing screw head inside
the channel. Locate 3 clips in front and back. 2 clips to
each side, and arrange spacing evenly around the sink.
Position the clip assembly parallel to the channel.
Place the sink carefully into the cutout opening and be
sure it is properly seated. Make sure sink rim covers of the
sink rim caulking all around. Press down firmly around
perimeter.
Rotate clamp of the clip 90 degrees to the channel and
tighten screw clockwise from the center clip using long
screw driver.
the channel. Locate 3 clips in front and back. 2 clips to
each side, and arrange spacing evenly around the sink.
Position the clip assembly parallel to the channel.
Place the sink carefully into the cutout opening and be
sure it is properly seated. Make sure sink rim covers of the
sink rim caulking all around. Press down firmly around
perimeter.
Rotate clamp of the clip 90 degrees to the channel and
tighten screw clockwise from the center clip using long
screw driver.
Insert clips into the channel, placing screw head inside
the channel. Locate 3 clips in front and back. 2 clips to each
side, and arrange spacing evenly around the sink. Position
the clip assembly parallel to the channel.
Place the sink carefully into the cutout opening and be
sure it is properly seated. Make sure sink rim covers
caulking all around. Press down firmly around perimeter
of the sink rim.
Rotate clamp of the clip 90 degrees to the channel
and tighten screw clockwise from the center clip using long
screw driver.
the channel. Locate 3 clips in front and back. 2 clips to each
side, and arrange spacing evenly around the sink. Position
the clip assembly parallel to the channel.
Place the sink carefully into the cutout opening and be
sure it is properly seated. Make sure sink rim covers
caulking all around. Press down firmly around perimeter
of the sink rim.
Rotate clamp of the clip 90 degrees to the channel
and tighten screw clockwise from the center clip using long
screw driver.
3
Insert bolt (with L-clip attached) horizontally into round
opening on the bracket.
Swing the bolt down vertically; the spacer between the threads
will self-center the bolt.
Grasp the L-clip and ensure long side is facing out and away
from sink. Turn bolt clockwise; this action will begin
snugging up the L-clip towards the underside of countertop.
opening on the bracket.
Swing the bolt down vertically; the spacer between the threads
will self-center the bolt.
Grasp the L-clip and ensure long side is facing out and away
from sink. Turn bolt clockwise; this action will begin
snugging up the L-clip towards the underside of countertop.
9.
10.
11.
9.
10.
11.
9.
10.
11.
I-Channel System
I-Channel System
J-Channel System
J-Channel System
COUNTE R TOP
SI NK
Tighten all clips evenly and do not over tighten as damage can result.
Install drain and water supply fitting as necessary. Wipe excess caulking compound and check carefully
as some adjustment for position and tightness may be required.
as some adjustment for position and tightness may be required.
12.
13.
U-Channel System
U-Channel System