Viking RVGR33015BWHLP Installation Instruction
21
20
Only authorized replacement parts may be used in performing service on the appliance.
All servicing should be referred to a qualified technician.
All servicing should be referred to a qualified technician.
Contact Viking Range, LLC 1-888-845-4641, for the nearest service parts distributor in your area
or write to:
or write to:
VIKING RANGE, LLC
PREFERRED SERVICE
111 Front Street
Greenwood, Mississippi 38930 USA
The model and serial number can be found by either tilting range back or
using a mirror to look underneath on the front edge of the bottom base.
using a mirror to look underneath on the front edge of the bottom base.
Record the following information indicated below. You will need it if service is ever required.
Model number
____________________________________________________________________________________
Serial number
_____________________________________________________________________________________
Date of purchase
__________________________________________________________________________________
Date installed
______________________________________________________________________________________
Dealer's name
_____________________________________________________________________________________
Address
___________________________________________________________________________________________
These installation instructions should remain with the unit
for future reference.
Service & Registration
Performance Checklist
A qualified installer should carry out the
following checks:
following checks:
□ Check top burner
ignition. See drawing
for proper flame
height on HI. The low
flame should light at
every port.
for proper flame
height on HI. The low
flame should light at
every port.
□ Check oven bake function—bake burner on
full power.
□ Check convection fan function—convection
fan comes on when put in Convection Bake
mode.
mode.
□ Check broiler function.
□ Check self-clean function—door will lock in
approximately 30 seconds, the broil and
bake burner will turn on. Check broil burner
through window to make sure they are on,
then abort self-clean cycle to unlock door.
bake burner will turn on. Check broil burner
through window to make sure they are on,
then abort self-clean cycle to unlock door.
Final Preparation
• All stainless steel body parts should be
wiped with hot, soapy water and with a
liquid cleaner designed for this material.
If buildup occurs, DO NOT use steel wool,
abrasive cloths, cleansers, or powders!
If it is necessary to scrape stainless steel
liquid cleaner designed for this material.
If buildup occurs, DO NOT use steel wool,
abrasive cloths, cleansers, or powders!
If it is necessary to scrape stainless steel
to remove encrusted materials, soak with hot,
wet cloths to loosen the material, then use a
wool or nylon scraper. DO NOT use a metal
knife, spatula, or any other material tool to
scrape stainless steel! Scratches are almost
impossible to remove.
wet cloths to loosen the material, then use a
wool or nylon scraper. DO NOT use a metal
knife, spatula, or any other material tool to
scrape stainless steel! Scratches are almost
impossible to remove.
1-1/2”
(3.8 cm)
(3.8 cm)
3/8”
(0.95 cm)
NOTICE
When conducting performance test,
DO
NOT run self-clean cycle for more than 10
minutes with oven racks inside oven. This
could cause them to discolor due to the
high temperature required for self-cleaning.
minutes with oven racks inside oven. This
could cause them to discolor due to the
high temperature required for self-cleaning.