GE GTD18ESSJWW Specification Sheet

Listed by 

Underwriters 

Laboratories

Special Installation Requirements
Alcove or Closet Installation: 

• If your dryer is approved for installation in an alcove or closet, it will be stated on a label  

  on the dryer back. 

• The dryer MUST be exhausted to the outside. 

•  Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 

0" either side; 3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”. 

•  Closet doors must be louvered or otherwise ventilated and must contain a minimum 

of 60 sq. in. of open area equally distributed. If this closet contains both a washer and 

a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.

• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.
Bathroom or Bedroom Installation:

• The dryer MUST be exhausted to the outdoors. 

•  The installation must conform with the local codes, or in the absence of local codes, 

with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.

•  Minimum clearances to combustible surfaces are: 0" both sides; 3" rear
Dryer Exhausting Information : Use metal duct only, vertical and horizontal ducting.

For answers to your Monogram,

® 

GE Profile

™

 or  

GE

®

 appliance questions, visit our website at 

geappliances.com or call GE Answer Center

®

 

service, 800.626.2000.

GTD18ESSJ 

GE

®

 6.8 cu. ft. capacity Dura Drum electric dryer

36

25-1/2

42

51

Side View

27

Rear View

36

42

27

2

3-1/2

2-1/2

25-1/2*

Side View

Rear View

8-1/2

28-1/4

23-1/2

11-1/2

*24-1/2" from the edge of the side panel to the front.

 25-1/2" from front to edge of endcaps.

Washer/Dryers SC QSart

5.7 cu. ft. Dryers

2

Back View

Power 

Cord Hole

30-1/2

5.8, 6.0 and 7.0 cu. ft. Dryers

5

Back View

Power 

Cord Hole

4-1/2

5600W

24A

60Hz

4400W

22A

60Hz

Exhaust Option: 4-way rear, right, left and bottom
Circuit Requirements:  An individual, properly-grounded branch circuit, 

protected by a 30-amp circuit breaker or a time-delay fuse, is required.
Note: Dryer wall outlet must be located within 36" of service cord entry 

and acessible when dryer is mounted in position.
Installation Information: For complete information, see installation 

instructions packed with your dryer.