Amana NGD4705EW Quick Setup Guide

Examine leveling legs and find diamond marking. Screw legs 

into leg holes by hand. Use a wrench to finish turning legs 

until diamond marking is no longer visible.

Now stand the dryer on its feet. Slide the dryer until it is 

close to its final location. Leave enough room to connect the 

exhaust vent.

Gas dryers must be securely fastened to the floor.

Mobile home installations require a Mobile Home Installation 

Hold-down Kit. For ordering information, please reference the 

“Use and Care Guide.”

Natural gas:
This dryer is equipped for use with Natural Gas. It is design-

certified by CSA International for LP (propane or butane) gases 

with appropriate conversion.

 

■

Your dryer must have the correct burner for the type of gas  

in your home. Burner information is located on the rating  

plate in the door well of your dryer. If this information does  

not agree with the type of gas available, please reference the 

“Assistance or Service” section of the “Use and Care Guide.” 

LP gas conversion:
Conversion must be made by a qualified technician.
No attempt shall be made to convert the dryer from the gas 

specified on the model/serial rating plate for use with a different 

gas without consulting the serving gas supplier.

IMPORTANT: The gas installation must conform with local codes, 

or in the absence of local codes, with the National Fuel Gas 

Code, ANSI Z223.1/NFPA 54 or the Canadian Natural Gas and 

Propane Installation Code, CSA B149.1.