Marvel ML24BNS1RB Owner's Manual

24

Mounting

bracket

Screws (4)

Remove foam plug 

from hole port

If the CO

2 

tank is placed on the floor it must be secured in 

the upright position with a chain or other means to prevent 

it from being tipped over.

Reseal hole 

around tubing with 

the foam plug

CO

2 

tank 

placed in the 

bracket

Figure 42

Figure 43

Many options are available for mounting the CO

2 

tank out-

side of the beer dispenser to gain additional cold storage 

space inside.

Mount the (4) screws (#10-32 x 

3

⁄

4

" flathead machine 

screws) provided with the bracket in the rear of the appli-

ance, see Figure 42. Do not completely tighten. Place the 

keyhole slots in the flanges of the bracket over the four 

screws and tighten them to secure the bracket to the back 

of the cabinet. The bracket can also be fastened to adja-

cent cabinetry using the provided #10 x 

3

⁄

4

" wood screws.

Mark the hole locations where required using a pencil and 

the slots in the mounting bracket. Drill appropriate pilot 

holes (depending on the material you are mounting to) and 

secure the bracket per the above instructions. 

Consider the length of the red air line when choosing a 

place for the CO

2 

tank.

With the gauges mounted to the CO

2 

tank place the tank in 

the mounting bracket.

Remove the foam plug from the hole port as shown in Fig-

ure 42, and feed the red CO

2 

line through the rear wall and 

out the coil cover on the inside of the cabinet. Connect the 

red CO

2 

line to the keg coupler.

Reseal the hole in the back of the cabinet with the foam 

plug. See Figure 43.

The optional mounting bracket is designed to hold the 5# 

CO

2 

cylinder that comes with the beer dispenser. Larger 

cylinders may be purchased from a third party and mounted 

externally. Use the hole port on the rear of the cabinet to 

run the CO

2

 line to the keg.