Marvel ML24BNS1RB Owner's Manual

27

The dispensing system needs to be cleaned between 

usage to prevent spoilage and/or foul taste in your beer.

This is an optional item (part number 42242373) Kit in-

cludes everything to quickly clean tap. Includes cleaning 

solution, pump, mixing bottle, brush and wrench.

Turn off the gas supply with the shutoff valve(s) under the 

regulator (see Figure 45 or 46) and open the faucet to re-

lieve the pressure. To remove the faucet from the tower use 

the spanner wrench provided. Place the pin on the wrench 

into the hole on the faucet collar and turn clockwise 

↷ to 

remove the faucet. (See Figure 50). 

Remove the knurled cap from the faucet body just below 

the handle and pull the handle assembly from the faucet. 

This will allow the shaft to be removed from the back of the 

faucet, see Figure 49.

Remove the keg coupler from the keg if necessary. Close 

the gas valve(s) below the regulator, remove both the red 

gas line(s) and clear beer line(s) from the keg coupler(s) by 

removing the plastic hose clamps (See Figure 52). Soak 

and brush the keg coupler in hot water or a sanitizing solu-

tion. Dry all parts and reassemble.

Soak all faucet parts in hot clear water or a solution of hot 

water and a sanitizing solution. Do not use soap.

Reassemble faucet, assemble faucet to tower (be sure 

faucet is in off position), and turn on gas valve.

Figure 50

Figure 49

After removing the 

handle the shaft will 

slide out the back of the 

faucet

Unscrew knurled 

cap on faucet body 

and remove handle 

assembly

Place pin on 

wrench into hole 

in faucet collar.

Figure 51

Figure 52

Hose clamps can be 

released by a lateral 

movement to the head.