GE GTD86ESSJWS Specification Sheet

Listed by 

Underwriters 

Laboratories

For answers to your Monogram,

® 

GE Profile

™

 or  

GE

®

 appliance questions, visit our website at 

geappliances.com or call GE Answer Center

®

 

service, 800.626.2000.

GTD86ESSJ/ESPJ 

GE

®

 7.8 cu. ft. capacity electric dryer with stainless steel drum and steam

5000W

25A

60Hz

4784W

23A

60Hz

Exhaust Option: 4-way rear, right, left and bottom
Circuit Requirements:  An individual, properly-grounded 

branch circuit, protected by a 30-amp circuit breaker or a 

time-delay fuse, is required.
Note: Dryer wall outlet must be located within 36" of service 

cord entry and acessible when dryer is mounted in position.
Installation Information: For complete information, see 

installation instructions packed with your dryer.

Special Installation Requirements
Alcove or Closet Installation: 

• If your dryer is approved for installation in an alcove or closet, it will be stated on a label  

  on the dryer back. 

• The dryer MUST be exhausted to the outside. 

•  Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 

0" either side; 3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”. 

•  Closet doors must be louvered or otherwise ventilated and must contain a minimum 

of 60 sq. in. of open area equally distributed. If this closet contains both a washer and 

a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.

• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.
Bathroom or Bedroom Installation:

• The dryer MUST be exhausted to the outdoors. 

•  The installation must conform with the local codes, or in the absence of local codes, 

with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.

•  Minimum clearances to combustible surfaces are: 0" both sides; 3" rear
Dryer Exhausting Information : Use metal duct only, vertical and horizontal ducting.