Amana NFW5800DW Quick Setup Guide

Loosen bolts with a 1/2" (13 mm) wrench. Slide each bolt and 

spacer to center of hole. Pull bolts and plastic spacers from 

back of washer. Discard bolts and spacers.

Close bolt holes on cabinet back with four transport bolt hole  

plugs included with washer parts.

Pull power cord through opening in rear panel and close hole 

with attached cap.

 If washer is transported at later date, call your local 

service center to avoid suspension and structural damage, 

a certified technician must properly set up washer for 

relocation.

Remove the yellow shipping strap from the cord. Gently 

place power cord over top of washer to allow free access 

to back of washer.
IMPORTANT: Do not plug washer in until installation has 

been completed. 

If clamp is not already in place on elbow end of drain hose,  

squeeze clamp with pliers and slide it over end of hose, 

centering it between the ribs, as shown. Squeeze clamp with 

pliers and slide elbow end of drain hose onto drain port and 

secure with clamp.

For a laundry tub or standpipe drain, go to step 9. 

For a floor drain, remove the preinstalled drain hose form  

as shown in Step 8. You may need additional parts with 

separate directions. See “Alternate Parts”.

Ribs