Verona VECTEM304 Use & Care Manual

12

If a hot surface light is ON use caution when working 

around the cooktop as it is still hot.

Once a heating element has been selected, touch the 

[FAST BOIL] key to enable/disable this function, before 

or after setting the power level. 
A beep sounds and the heater display shows the 

selected power level and a “P” alternatively. The 

“Peacock Tail” shows the selected power level.
The heater works at full power (level 9, always on) for 

10 minutes. After these 10 minutes the heater returns 

to the selected power level.
This option is available for all the cooking zones, both 

standard, both special ones (multiple zones or bridge).

The key lock function is activated or deactivated holding 

the [LOCK] key for 2 seconds. The lock indication turns 

on, the keyboard is locked. Of course, the [LOCK] key 

itself is always enabled.
The keys are automatically locked at start-up.
The locking function can be activated regardless of the 

heaters condition (working or not). The key lock function 

locks all the keys but the [OFF] ones. Also the general 

[ON/OFF] key remains active for the off function. 

The timer is available in some models only. It can be set 

independently from the heating element, even if there 

aren’t any working zones. If the cooktop is not working, 

touch  first  the  main  [ON/OFF]  key  to  enter  stand-by 

mode, with all displays showing “0”. 

Touch [T-] or [T+] keys to set the timer: the initial value 

starts from “00” or “45” respectively on the timer display 

(ref.1). Hold the key in order to fasten the increase/

decrease speed. The maximum value is “99”.
The timer led (ref.2) indicates whether the timer is 

running.
The dot in the lower right corner of the display (ref.3) is 

flashing when the timer has been selected in order to 

change its value. After 5 seconds since the last touch 

the new value is accepted and the dot disappears. 

A  beep  confirms  that  the  new  value  was  accepted 

correctly.
To cancel the timer, hold [T-] key until the value decrease 

to “00” or touch both [T-] and [T+] simultaneously in 

order to reset the value to “00” rapidly.
In some models the timer can be set in relation with a 

cooking zone:
•  Select the cooking zone you want to time.

•  Touch [T-] or [T+], the timer led related to the zone 

starts flashing.

•  Set the timer value.

•  The timer led gets steady, the value is accepted and 

the countdown begins.

If more than one timer is set, the display shows the 

lowest value, the one that will expire first. The timer led 

(ref.4) related to the zone which the displayed value is 

referring to, is flashing. If the displayed value refers to 

the independent timer, the timer led (ref.2) flashes.

To check the remaining time for any one of the timed 

zone, touch the [ON] key related to the zone: the 

corresponding timer led will begin to flash and the value 

on the timer display will switch for some seconds to the 

new value. After a time-out, it will switch back to the 

shortest one.
To check the independent timer value when it’s not 

displayed with the highest priority, touch [T-] or [T+] when 

no zones are selected. The timer led (ref.4) flashes and 

the displayed value switches to the independent timer.