GE JVM7195 Installation Instruction

  Find the studs, using one of the following methods:
  A.  Stud finder – a magnetic device which locates nails.

  B.  Use a hammer to tap lightly across the mounting 

surface to find a solid sound. This will indicate  

a stud location.

  After locating the stud(s), find the center by probing  

the wall with a small nail to find the edges of the stud. 

Then place a mark halfway between the edges.  

The center of any adjacent studs should be 16s or 24s 

from this mark.

  Draw a line down the center of the studs.
IMPORTANT:  The microwave must be connected to at 

least one wall stud.

  Remove the box containing the installation 

instructions, filters, exhaust adaptor, damper  

and the small hardware bag. Do not remove  

the foam packing protecting the front of the oven.

  Fold back all 4 carton flaps fully against carton sides. 

Then carefully roll the oven and carton over onto  

the top side. The oven should be resting in the foam 

packing.

Wall  

Studs

Center

Carton

  Pull the carton up and off the oven. 

   Open the oven door and remove the foam pack 

from inside the oven. Remove the tape covering the 

turntable hub.

Foam 

packing

  Set the oven upright. Remove and properly discard 

plastic bags and foam packing.

  The mounting plate is attached to the back of the 

oven. Remove the two screws holding it to the oven.  

The plate will be used as the rear wall template and 

for mounting the oven to the wall.