Lynx L400PS Use & Care Manual

SEDONA CARE & USE/INSTALLATION

Final cHecKS

clear of dirt, debris, or spider webs. If clear, then adjust the
air shutter.

It is locked in place by a screw which must be loosened
before adjusting. Once adjusted retighten the screw.

TO ADjUST:

• Remove the racks and briquette trays.
• Remove the hex head bolt securing the burners.
• Lift out the burner, loosen the set screw and then put the

burner back in place and light it.

• If the flame is excessively yellow, indicating insufficient air,

CAREFULLY turn the air shutter counterclockwise to allow
more air to the burner.

• If the flame is noisy (sounds like a torch) and tends to lift

away from the burner, indicating too much air, turn the air
shutter clockwise.

• After the burner cools down, remove it, tighten the air

shutter set screw and reinstall the burner, briquette trays
and grill racks.

NOTE: The ProSear™ does not have an air shutter.

• The appearance of the

ProSear™ burner should be
visually checked. The ceramic
tiles should be uniformly red to
orange in appearance. There
should be no lifting, fluttering or
lazy blue flames. Some food par-
ticles will show as yellow flames
but should burn off.

ONE LAST ThING

Finally, before leaving, check all the burners for proper
operation. Make sure the control knobs turn freely and
completely through their full range.

ImPortant:
make sure the owner knows where the main gas supply
shut off valve is located.

finally, for safety and for proper use & care, you must
leave this manual with the owner. make sure you advise
them to keep it for future reference.

For technical assistance call:
lynx Customer Care
888-289-5969

danger

BE EXTREMELY CAREFUL AROUND HOT BURNERS
AND OTHER GRILL PARTS.