Vinotemp VT140TS Owner's Manual
INSTALLATION
• Remove all packing material before using your wine cooler.
• IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately 24
• IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately 24
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
transportation.
• Clean the interior surface with lukewarm water and a soft cloth.
• This unit is designed for freestanding or built in installation but indoor use only. Position the unit in a dry
• This unit is designed for freestanding or built in installation but indoor use only. Position the unit in a dry
and well-ventilated place. Avoid placing the wine cooler near any source of heat or moisture, or in direct
sunlight. Do NOT install the unit in a location with an ambient temperature that will fall below 60°F.
sunlight. Do NOT install the unit in a location with an ambient temperature that will fall below 60°F.
• To allow for proper circulation, the wine cooler requires at least a 5" clearance at both the back and
sides of the unit. For best performance, do not install the unit behind a cabinet door or block the base
grille.
grille.
• Place the wine cooler on a level surface strong enough to support it when it is fully loaded. To level the
wine cooler, adjust the front leveling legs at the bottom of the wine cooler.
• For best performance it is recommended that you install the appliance in a location with an ambient
temperature between 72°-78°F. If the ambient temperature is above or below recommended
temperatures, the performance of the unit may be affected.
temperatures, the performance of the unit may be affected.
• Plug the wine cooler into an exclusive, properly installed-grounded wall outlet.
OPERATING YOUR WINE COOLER
CONTROLS
c
F
Power
To turn the appliance ON or OFF, touch the and at the same time for 5 seconds.
Set
Set or view the internal temperature setting for each zone.
Light
Turn the inner light ON or OFF.
Up
Raise the set temperature by 1°C or 1°F.
Down
Lower the set temperature by 1°C or 1°F.
ºF/ºC Selector
Choose to display temperature setting in Fahrenheit or Celsius. To change the temperature display from
Fahrenheit to Celsius or from Celsius to Fahrenheit, touch and hold for 5 seconds.
Fahrenheit to Celsius or from Celsius to Fahrenheit, touch and hold for 5 seconds.
Key Lock
After 2 minutes of inactivity, the controls will be locked automatically. To release the lock, touch the and
at the same time for 5 seconds.
8
W W W . V I N O T E M P . C O M