Dacor ER48D Use & Care Manual

Setting Up Your Range

Control Panel Settings

Setting the Time

IMPORTANT:
•

The clock cannot be set during delay timed cooking or if one

or both timers are in use.

•

After a power failure, the time on the display may flash, indi-

cating that the time may not be correct.

To set the time:

1. Press the CLOCK key. “TIME” will flash on the display.
2. Enter the current time and press START. For example: For

12:08 Press 1-2-0-8 on the keypad, then START.

IMPORTANT: After pressing the clock key, you must enter the

time and press START soon afterward. If you wait longer than six

seconds between pressing keys, the display will go back to the

original setting.

24/12 Hour Clock (Military Time)

The range is set to 12-hour (non-military) time at the factory.

24- hour time is also known as military time. 1:36 PM = 13:36

military time.

If you want to switch the clock to 24 hour time or

switch from military back to regular time:

1. Press and hold the clock key for six seconds. The display will

indicate the mode the clock is currently set to, 12 HR or 24

HR.

2. Press the SELF CLEAN key within six seconds to change the

clock mode. To leave the setting as is, do not touch any keys.

3. Wait six seconds. The control panel will go back to the regular

clock display, set to the new time standard. If you have set

the clock to 24 hour time, the keypad will allow you to enter

military time when setting the clock.

Setting the Temperature Scale

The control panel allows you to select the temperature scale

(Fahrenheit or Celsius) it uses to display the cooking temperature.

The oven is preset at the factory to Fahrenheit.

To change the temperature scale:

1. Press and hold the BROIL key for six seconds.
2. The display will indicate the temperature scale the control

panel is currently set to, “F” or “C”.

3. Press the SELF CLEAN key within six seconds to change the

temperature scale. To leave the setting as is, do not touch

any keys.

4. Wait six seconds. The control panel will go back to the regular

clock display, set to the new temperature scale.

Control Panel Position

The control panel can be swiveled to a 50° angle for easier view-

ing and use.

To pivot the control panel:

1. Push in on the bottom of the control panel where it says

“PRESS HERE.” The control panel will pivot up.

2. Pull up on the bottom of the control panel housing (under

“PRESS HERE”) until it locks in place.

To put the control panel back in the vertical position:

1. Pull up on the bottom of the control panel housing (under

“PRESS HERE”) to unlock it.

2. Push in where it says “PRESS HERE” until it locks into the

vertical position.

CAUTION

When changing the control panel position, push in only on the

spot marked “

PRESS HERE”. If you push in on the right or left

side you may damage the pivot mechanism.

Clock key

Press here