Thermador T18ID800LP Installation Instruction
14
2.
Attaching an alternative anti-tip
device
device
Important note:
If the anti-tip brackets cannot be attached securely,
an alternative anti-tip-device can be attached. However,
ensure that there is no play between the appliance and
the anti-tip-device. If possible, always screw the wooden
beam to existing studs on the rear panel of the
installation enclosure.
1.
If the anti-tip brackets cannot be attached securely,
an alternative anti-tip-device can be attached. However,
ensure that there is no play between the appliance and
the anti-tip-device. If possible, always screw the wooden
beam to existing studs on the rear panel of the
installation enclosure.
1.
Saw the wooden beam (cross section min. 3" x 4")
to the required length. Length is equal to the width
of the installation enclosure!
to the required length. Length is equal to the width
of the installation enclosure!
Note:
If the installation enclosure is deeper than the
appliance, select a beam which has a larger
cross section or attach 2 beams.
appliance, select a beam which has a larger
cross section or attach 2 beams.
The beam must cover the appliance by
at least 2" (50.8 mm).
at least 2" (50.8 mm).
2.
Mark the installation height (lower edge of the beam)
on the rear panel of the installation enclosure.
on the rear panel of the installation enclosure.
3.
Select screws according to the thickness of the
wooden beam: length = min. 2.5 x beam thickness,
diameter #12 or #14.
Note:
Choose the number of screws according to the
installation enclosure width, thereby ensuring that
the beam can be attached securely.
wooden beam: length = min. 2.5 x beam thickness,
diameter #12 or #14.
Note:
Choose the number of screws according to the
installation enclosure width, thereby ensuring that
the beam can be attached securely.
4.
Depending to the subsurface:
Locate wall studs in the rear of the installation
enclosure and accordingly transfer their location to
the wooden beam
or
fasten suitable dowel into the rear wall.
Locate wall studs in the rear of the installation
enclosure and accordingly transfer their location to
the wooden beam
or
fasten suitable dowel into the rear wall.
5.
Predrill the wooden beam.
6.
Attach the wooden beam to the rear panel of the
installation enclosure.
installation enclosure.
3.
Attaching an edge protection
To protect the edges of the installation enclosure,
it is recommended to attach edge protection
made of a suitable material.
it is recommended to attach edge protection
made of a suitable material.
4.
Attaching the fastening sheets
(lateral)
(lateral)
Attach the fastening sheets (lateral) to the appliance.
These are special installation steps.
Instructions are provided after section C.
Instructions are provided after section C.
Change over door hinge, see
“Changing over the door hinges”.
“Changing over the door hinges”.
Sealing mat, see “Removing/
changing over the sealing mat”
changing over the sealing mat”
Side-by-Side installation, see “Side-
by-Side installation”.
by-Side installation”.
Connecting the water, see “Preparing
to connect the water”.
to connect the water”.