Thermador T18ID800LP Installation Instruction
19
3.
Switching the appliance ON
To guarantee the accuracy of the following working steps
and thus the appearance of the overall kitchen front later
on, the appliance should now be operated.
and thus the appearance of the overall kitchen front later
on, the appliance should now be operated.
1.
Open the appliance door.
2.
Press the POWER button.
3.
Press the POWER button again to shut off.
Only for appliances with a water connection:
In order to avoid the risk of damage caused by leaking
water from damage possibly caused to the water pipe
feeding the appliance, keep the shut-off valve closed.
water from damage possibly caused to the water pipe
feeding the appliance, keep the shut-off valve closed.
4.
Preparing the door panels
Important note:
When performing any work on the door panels, always
observe the following:
observe the following:
Always screw into the best load-bearing material of
the door panel.
the door panel.
Never screw into fillers, decorative strips or similar.
Select a screw length which is always shorter than
the thickness of the door panel.
the thickness of the door panel.
To prevent damage, protect surfaces of the door
panels during installation.
panels during installation.
The total weight of the door panel must not exceed the
following values:
following values:
18" Appliance
44 Ibs/20 kg (19 lbs/8.5 kg *)
24" Appliance
55 Ibs/25 kg (32 lbs/14.5 kg *)
30" Appliance
64 Ibs/29 kg
(* Wine unit)
In the case of 30" and 36" wide appliances 2 adjacent
door panels can be attached instead of one large door.
These door panels must be connected to a metal strip
on the rear.
door panels can be attached instead of one large door.
These door panels must be connected to a metal strip
on the rear.
This metal strip can be purchased from customer service
as an optional accessory, see the section on “Required
accessories and tools/Optional accessories”.
as an optional accessory, see the section on “Required
accessories and tools/Optional accessories”.
Note:
The instructions for carrying out this work step can be
found in the separate installation instructions for this
accessory.
found in the separate installation instructions for this
accessory.
5.
Loading the appliance door
When attaching the door panels, it is recommended to
load the door storage compartments in the appliance
with weights in order to ensure that the gap width is as
precise as possible.
load the door storage compartments in the appliance
with weights in order to ensure that the gap width is as
precise as possible.
Recommendations:
18" Appliance:
22 lbs/10 kg
24" Appliance:
33 lbs/15 kg
30" Appliance:
44 lbs/20 kg
6.
Removing the installation support
part
part
Unscrew the positioning aid from the appliance door.
Note:
Store the positioning aids, there will be used in an
installation step later.
installation step later.