Thermador WDC36J Installation Instruction

Attach Custom Drawer Front

1. On the back side of the panel, mark the pilot holes of 

the custom drawer front at the locations and 
specifications indicated in Figure 5 and Figure 6. 

2. Drill pilot holes. Be careful not to drill all the way 

through the panel! Pilot holes should only be 7/16” 
(11 mm) deep.

3. Attach drawer front with four (4) 1/2” (12.7 mm) screws 

through the back side of drawer front (Figure 7).

1. Turn power OFF at the service panel. Lock service 

panel to prevent power from being turned ON.

2. Install electrical connection and prepare cabinet cutout 

according to the dimensions for the applicable model 
stated in “General Information”.

--

SUGGESTION
Saw blades can splinter and chip cabinet facing. To 
better protect cabinetry, after measuring and marking 
the cut line with a pencil, cover the wood with a piece of 
masking tape along the top of the line to be cut.

3. Position the anti-tip bracket on the floor of cabinet 

opening 20

⅝

” (524 mm) from the cabinet edge and 

spaced equally centered for model type, as shown in 
Figure 8. 

Custom front panel

Custom front panel

Custom front panel

Before installing, turn power OFF at the service panel. 
Lock service panel to prevent power from being turned 
ON accidentally.

It is recommended to have two installers to 
install warming drawer. Failure to do so may 
result in property damage or personal injury.